Make these kites in bright colours and co-ordinate the ribbons on the tails for a lightweight breezy decoration. This project was designed by Sammy Claridge from Sew Crafty. It’s a taster of our fat quarter projects, which are great for beginners. To see more like this, check out our Fast Fat Quarter blog series of easy sewing projects, or why not treat yourself to our new Fat Quarter Collection magazine – out next week but available to preorder now.
You will need
- Cotton fabric: four fat eighths or scrap
- Bondaweb: 50cm (20in)
- Heavy weight iron-on interfacing: 25cm (10in)
- Bakers twine: 3m (120in)
- Ribbon: 1.5cm (5/8in) width, short lengths
- Embroidery hoop: 25cm (10in) diameter
- Air erasable marker pen
- Basic sewing kit
All materials available at Sew Crafty.
Before you begin, download our free kite template (PDF). Scroll down to get sewing your mobile!
Step-by-step: how to make a mobile
Step one: Iron the interfacing onto the back of all of the fabric scraps. Iron a layer of bondaweb over the top of the interfacing with the paper side up.
Step two: Remove the paper backing then fold one piece of fabric in half and iron again to stick all the layers together and create a fabric sandwich. Draw round the template with erasable marker and cut out.
Step three: Repeat steps 1 and 2 to create each kite.
Step four: Cut a 15cm (6in) length of bakers twine and four ribbon scraps. Tie a knot in the ribbons around the bakers twine to make little bows, spacing them evenly along the length of twine. Snip off any excess ribbon to neaten. Tie a knot in each end of the bakers twine.
Step five: Repeat step 4 to create a tail for each kite.
Step six: Sew one end of the tail to the longer point on the kite.
Step seven: Sew all the way around the edge of the kite, 5mm (1⁄4in) in, to keep all the layers together permanently.
Step eight: Tie two 75cm (30in) lengths of bakers twine to your hoop, crossing over in the middle to create a loop for hanging.
Step nine: Sew 20-25cm (8-10in) lengths of monofilament to the three top corners of each kite.
Step ten: Tie each kite in place on hoop where the bakers twine is knotted to it.